Improper treatment of *SMET in SNOWPACK - ILWR not consistent in virtual slope simulations
This issue was reported by Bettina Richter.
Steps to reproduce the problem:
-
Perform slope simulation with SNOWPACK
-
io.ini: No special commands: Flat field uses measured ILWR Slope does not use ILWR
-
io.ini: [SnowpackAdvanced] MEAS_INCOMING_LONGWAVE=True -> ILWR is used for both, flat field and slope
-
io.ini: [SnowpackAdvanced] MEAS_INCOMING_LONGWAVE=False -> ILWR is used for flat field -> ILWR is not used for slope
-
io.ini: [SnowpackAdvanced] MEAS_INCOMING_LONGWAVE=False [Input] *::EXCLUDE = ILWR -> ILWR is not used for flat field -> ILWR is not used for slope
-
This should be standardized, since it is not in line with the an Alpine3D simulation using the same input and values in io.ini